Logging in to the internal web interface
-
Open a web browser (i.e. Internet Explorer, Firefox, Chrome).
-
Enter the IP address of the product in the address field.
-
Login with username admin and password admin.
Reviewing status and information about the product
-
Log in to the internal web interface.
-
Select Status in the left menu.
The product supports both DCHP and static IP settings.
-
Log in to the internal web interface.
-
Select Network in the left menu.
Current IP settings are shown.
-
Select Configuration to change the IP settings.
Depending on which settings changed, the product may need to reboot.
-
Select Link to change speed and duplex settings.
Configuring M-Bus transparent server settings
The product handles incoming TCP/IP connections and establishes a transparent link to the M-Bus interface.
-
Log in to the internal web interface.
-
Select M-Bus TCP/IP in the left menu.
-
Select Accept Mode to change TCP server listening port and keep-alive settings.
-
Select Disconnect Mode to change disconnect timeout.
Configuring M-Bus transparent local baud rate
-
Log in to the internal web interface.
-
Select M-Bus Serial in the left menu.
The M-Bus local serial line statistics are shown.
-
Select Configuration to change local M-Bus baud rate.
Configuring internal web interface settings
The internal web interface can handle different users and HTTPS when required
-
Log in to the internal web interface.
-
Select HTTP in the left menu.
The internal web interface statistics are shown.
-
Select Configuration to change internal web interface server settings.
-
Select Authentication to change security settings.
-
Log in to the internal web interface.
-
Select System in the left menu.
-
Select Reboot to reboot the device.
Boot time is approximately 10 seconds.
Resetting to factory default settings via the web interface
-
Log in to the internal web interface.
-
Select System in the left menu.
-
Select Factory Defaults to reset to factory default settings.
Updating the product remotely
The product can be remotely updated by uploading new firmware in the internal web interface.
-
Log in to the internal web interface.
-
Select System in the left menu.
-
Select Browse to select the firmware file.
-
Select Upload to start firmware update process.
Firmware file name should be named cme3000.romz.
The latest firmware file can be found on Elvaco website, Elvaco AB .
Comments (0 comments)