Configuration

Setting up the sensor in the LCD display

The sensor is equipped with a display with two different modes: standard mode and setup mode. The sensor is configured in setup mode.

Note

Setup mode is only available for authorized personnel.

Press and hold the push button SW1 for 5 seconds (with the LCD display off) to enter setup mode.
Press and hold the push button SW1 for 2 seconds to go through the configurable parameters.
To configure a parameter, press push button SW2. If there are more than one configurable parameter on a page, press push button SW1 to switch between them.

Setup mode

Resetting the sensor settings in the LCD display

Press and hold the push button SW1 for 5 seconds (with the LCD display off) to enter setup mode.
Press and hold the push button SW1 for 2 seconds to until Total Reset is displayed.
Select y.

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request

Comments (0 comments)

Article is closed for comments.