Configuration

Setting up the sensor in the LCD display

The sensor is equipped with a display with two different modes: standard mode and setup mode. The sensor is configured in setup mode.

Note

Setup mode is only available for authorized personnel.

  1. Press and hold the push button SW1 (4) for 5 seconds (with the LCD display off) to enter setup mode.

  2. Press and hold the push button SW1 for 2 seconds to go through the configurable parameters.

  3. To configure a parameter, press push button SW2 (2). If there are more than one configurable parameter on a page, press push button SW1 (4) to switch between them.

    CMa10/11_setup_mode

    Setup mode

Resetting the sensor settings in the LCD display

  1. Press and hold the push button SW1 (4) for 5 seconds (with the LCD display off) to enter setup mode.

  2. Press and hold the push button SW1 for 2 seconds to until Total Reset is displayed.

  3. Select y.

Was this article helpful?

0 out of 0 found this helpful
Have more questions? Submit a request

Comments (0 comments)

Article is closed for comments.