Troubleshooting

The product does not respond to M-Bus master commands

Cause
  • Fault in connection/configuration.

Solution

Verify that:

  • Voltage over M-Bus connection is between 21 VDC and 42 VDC.

  • All M-Bus slaves connected to the M-Bus master have unique primary addresses or secondary addresses depending on addressing mode.

  • M-Bus master baud rate is identical to M-Bus slave baud rate.

The product cannot control the connected unit

Solution

Disconnect the cables to the unit to be controlled, e.g. the actuator. Measure the output with a multimeter while an M-Bus command is sent to change the output. If this works, there is probably an error in the connection to the input of the unit to be controlled.

Was this article helpful?

0 out of 0 found this helpful
Have more questions? Submit a request

Comments (0 comments)

Article is closed for comments.